乌鲁木齐市不同区域大气降尘中重金属污染及来源分析

为进一步了解城市不同区域间大气降尘中重金属含量及其差异性,沿城市走向梯度布设降尘采样点采集样品。采用电感耦合等离子体原子发射光谱(ICP-AES)仪测定样品中Cu、Cr、Mn、Fe、Ni、Zn、Cd、Pb和As等重金属含量,并计算富集因子来判断不同区域间的污染源类型,通过因子分析方法探讨污染的来源。结果显示,所测重金属元素中除Mn外,均受到人为源的影响,且十分严重。从贡献率来看,不同区域间第一因子的贡献率虽有差异,但均为来自土壤的风沙扬尘造成;第二因子的贡献率也不尽相同,主要是燃煤产生的污染;第三因子出现了差异,市南区和市北区主要是受金属冶炼的影响,而市中区的影响可能来自垃圾焚烧;市南区未出现第四因子,而市中区和市北区的污染源也不相同。分析表明,城市大气降尘污染依然严重,做好防控风沙和建筑扬尘,减少煤炭消耗,调整能源结构和产业布局是整体减少大气降尘的关键。     

Trace element content in soils of the King George and Elephant islands,maritime Antarctica

Trace element concentrations were studied in soils of the King George and Elephant islands in the maritime part of West Antarctica. The lowest concentrations of Cu, Pb, Cd, Zn, Ni and Mn were typical for the pristine soil of Elephant Island. The highest concentrations of these elements were found in the Fildes Peninsula and revealed the influence of human activities in the area of the Bellingshausen station and adjacent waste disposal sites. Ornithogenic soils of the Fildes Peninsula have shown low concentrations of Cd and As. Using geoaccumulation indexes, all the pristine soils of King George and Elephant islands and ornithogenic soils of the Fildes Peninsula were classified as unpolluted; the human-affected soils were mainly identified as moderately polluted. Obtained data can be used as background concentration levels for further researches.     

镍渣的重金属浸出特性

在分析镍渣的矿物相组成和重金属元素含量的基础上,鉴定了镍渣样品的浸出毒性,并考察了pH、液固比和浸出时间等条件对镍渣样中铬、铅、铜和锌等重金属浸出特性的影响。结果表明,镍渣中的重金属总量约为渣样的0.9%,且铬、铜和锌的含量较高,需进行安全管理。实验所用镍渣样品为第Ⅰ类一般工业固体废物。在强酸条件下镍渣中重金属浸出浓度较大,pH3后浸出浓度显著降低;液固比40 L/kg时,镍渣中重金属不断溶出,液固比40 L/kg后,浸出达到饱和,浸出浓度趋于平衡;随着浸出时间的增加,重金属离子的浸出浓度先增加后减少,但由于各重金属性质不同,各重金属达到最大浸出浓度的时间不同。     

Suicide by crashing into a heavy vehicle: Focus on professional drivers using in-depth crash data

Objective: Road traffic suicides typically involve a passenger car driver crashing his or her vehicle into a heavy vehicle, because death is almost certain due to the large mass difference between these vehicles. For the same reason, heavy-vehicle drivers typically suffer minor injuries, if any, and have thus received little attention in the research literature. In this study, we focused on heavy-vehicle drivers who were involved as the second party in road suicides in Finland.

Methods: We analyzed 138 road suicides (2011–2016) involving a passenger car crashing into a heavy vehicle. We used in-depth road crash investigation data from the Finnish Crash Data Institute.

Results: The results showed that all but 2 crashes were head-on collisions. Almost 30% of truck drivers were injured, but only a few suffered serious injuries. More than a quarter reported sick leave following their crash. Injury insurance compensation to heavy-vehicle drivers was just above €9,000 on average. Material damage to heavy vehicles was significant, with average insurance compensation paid being €70,500. Three out of 4 truck drivers reported that drivers committing suicide acted abruptly and left them little opportunity for preventive action.

Conclusions: Suicides by crashing into heavy vehicles can have an impact on drivers’ well-being; however, it is difficult to see how heavy-vehicle drivers could avoid a suicide attempt involving their vehicle.     

南京市农用地土壤中重金属形态特征分析

以南京市农用地土壤为研究对象,采用顺序提取的方法对Cu、Zn、Pb、Cd做化学形态分析,了解不同元素各形态下空间赋存的含量与占比。结果表明,在农用地土壤中,上述4种金属元素所赋存的化学形态活泼性顺序为CdPbCuZn,其中Cd主要为醋酸提取态,Pb主要为可还原态,各占总量的40%以上,具有较高的生物有效性和潜在危害性;Cu与Zn主要为残渣态,占总量的60%左右,生物可利用性较低。由因子分析法可知,土壤p H值越大,Zn与Cd就越趋于向稳定的化学形态转化,土壤有机质含量越高,对Cu与Pb的络合能力就越强,可以降低其环境危害性。     

Characterisation of FOGs in grease trap waste from the processing of chickens in Thailand

Industrial firms that kill and process chickens generate wastewater that contains fat, oil, and grease (FOG). The FOGs are located in the fatty waste that is collected by floatation in grease traps. Chemical and physical characterisation of FOGs would provide useful information that would help in the development of methods designed to decrease the extent of pollution caused by disposal of the waste and to utilise commercially some of its lipid constituents. Employing these methods would enhance the profitability and competitive potential of these commercial organisations. Samples of grease trap waste from 14 firms in central Thailand have been examined. Due to the very different schemes of waste management employed by these firms, the physical appearance of their fatty wastes showed considerable variation. The chemical and physical properties of the FOGs present in these wastes showed considerable variation also. Large amounts of free fatty acids (10–70% as oleic acid) were detected in most of the 14 wastes and palmitic, cis-9-oleic, cis,cis-9,12-linoleic, stearic, and palmitoleic acids were the predominant species of free and esterified acids. Most of the FOGs were solid at temperatures below 40 °C. Many of them contained traces of heavy metals (Cu and Pb) and some contained traces of the pesticides dimethoate and cypermethrin. The content of these potentially hazardous substances would have to be considered very carefully before discarding the fatty wastes and during the development of methods designed to isolate their potentially profitable lipid constituents.     

Bioaccumulation of trace elements in wild-growing edible mushrooms from Lubuskie voivodeship,Poland

Cu, Cr, Mn, Ni and Zn contents were quantified for three wild-growing edible species of macrofungi (Boletus edulis, Macrolepiota procera and Cantharellus cibarius) and underlying soil samples collected at forest sites in Lubuskie voivodeship, Poland. The total concentration of the analysed elements was determined using an ASA iCE 3000 series atomic absorption spectrometer. The analysis found significant differences in bioaccumulation between species and differing distributions of trace elements in the caps and stalks of fruiting bodies. Bioaccumulation factors revealed that Zn and Cu are the most bioaccumulated elements, whereas Cr and Mn are excluded from bioaccumulation. Macrolepiota procera showed the highest bioaccumulation of Cu, and Zn is accumulated to the greatest extent by Boletus edulis. A few significant differences (p≤0.05) between the examined species were observed.     

Metal concentrations in used engine oils: Relevance to site assessments of soils

Used engine oils contain metals, which upon entering soils may pose risks to human health or the environment. In this study, previously published concentrations of 23 metals in 213 used engine oil samples from the early 1970s to the mid-1990s are statistically evaluated. Neat (100%) used engine oils were found to contain relatively high concentrations of lead, calcium, and zinc, attributable to piston blow-by of leaded gasoline, calcium salt detergent additives, and zinc-bearing anti-corrosion/anti-oxidation additives, respectively. Wear metal concentrations were lower. The lead concentration in used engine oils in the U.S. declined between the 1970s and early 1990s, potentially providing a basis to constrain the “age” of used engine oil(s) in soils. The concentrations of 23 metals in used engine oils were compared to soil risk benchmarks in 15 representative jurisdictions in the U.S., Canada, Australia, and Europe. The maximum concentrations in neat (100%) used engine oil of eight metals – Be, Co, Fe, Mn, Ni, Se, Ag, and Ti – were lower than their collective minimum benchmarks in soils for the jurisdictions surveyed, indicating their concentrations in soils could not be reasonably expected to exceed any soil benchmarks. Nine metals (As, Ba, Cd, Cr, Cu, Pb, Sn, V and Zn), but particularly arsenic, cadmium, lead, tin, and zinc, were identified as potential contaminants of concern (PCOC) for soils from locations impacted with used engine oils, owing to their higher median concentrations (i.e., 2.5, 1.4, 1038, 5.0, and 922 mg/kg in oil, respectively) relative to most soil benchmarks. Site-specific benchmarks and metal concentrations at reasonable oil in soil concentrations require consideration when developing the suite of PCOC metal analytes for conducting site assessments of soils impacted by used engine oil.     

Magnetotactic bacteria: Characteristics and environmental applications

• Magnetotactic bacteria (MTB) synthesize magnetic nanoparticle within magnetosomes. • The morphologic and phylogenetic diversity of MTB were summarized. • Isolation and mass cultivation of MTB deserve extensive research for applications. • MTB can remove heavy metals, radionuclides, and organic pollutants from wastewater. Magnetotactic bacteria (MTB) are a group of Gram-negative prokaryotes that respond to the geomagnetic field. This unique property is attributed to the intracellular magnetosomes, which contains membrane-bound nanocrystals of magnetic iron minerals. This review summarizes the most recent advances in MTB, magnetosomes, and their potential applications especially the environmental pollutant control or remediation. The morphologic and phylogenetic diversity of MTB were first introduced, followed by a critical review of isolation and cultivation methods. Past research has devoted to optimize the factors, such as oxygen, carbon source, nitrogen source, nutrient broth, iron source, and mineral elements for the growth of MTB. Besides the applications of MTB in modern biological and medical fields, little attention was made on the environmental applications of MTB for wastewater treatment, which has been summarized in this review. For example, applications of MTB as adsorbents have resulted in a novel magnetic separation technology for removal of heavy metals or organic pollutants in wastewater. In addition, we summarized the current advance on pathogen removal and detection of endocrine disruptor which can inspire new insights toward sustainable engineering and practices. Finally, the new perspectives and possible directions for future studies are recommended, such as isolation of MTB, genetic modification of MTB for mass production and new environmental applications. The ultimate objective of this review is to promote the applications of MTB and magnetosomes in the environmental fields.     

Full-scale blending treatment of fresh MSWI leachate with municipal wastewater in a wastewater treatment plant

Fresh leachate, generated in municipal solid waste incineration (MSWI) plants, contains various pollutants with extremely high strength organics, which usually requires expensive and complex treatment processes. This study investigated the feasibility of blending treatment of MSWI leachate with municipal wastewater. Fresh MSWI leachate was pretreated by coagulation–flocculation with FeCl₃ 2 g/L and CaO 25 g/L, plate-and-frame filter press, followed by ammonia stripping at pH above 12. After that, blending treatment was carried out in a full-scale municipal wastewater treatment plant (WWTP) for approximately 3 months. Different operational modes consisting of different pretreated leachate and methanol addition levels were tested, and their performances were evaluated. Results showed that throughout the experimental period, monitored parameters in the WWTP effluent, including COD (<60 mg/L), BOD₅ (<20 mg/L), ammonium (<8 mg/L), phosphorus (<1.5 mg/L) and heavy metals, generally complied with the Chinese sewage discharged standard. Under the experimental conditions, a certain amount of methanol was needed to fulfill TN removal. An estimation of the operation cost revealed that the expenditure of blending treatment was much lower than the total costs of respective treatment of MSWI leachate and municipal wastewater. The outcomes indicated that blending treatment could not only improve the treatability of the MSWI leachate, but also reduce the treatment cost of the two different wastewaters.